LSatan
LSatan
now I was also just finished to decode. it is a 24 bit code. my results: 101001001010010010100000 as I mentioned already rc switch does not comeclear with everything. It's not...
I think rc-switch receives itnot because there is a stop signal.
yes this is the plan, but it requires a comprehensive analysis of the received raw data and very complex. so that everything is covered. Writing something for your remote control...
Hi, interesting project. I can understand the general functionality based on a description. I should know how far it works. So at what point there are problems with receiving. 1....
I'm sorry. I have not seen that the sketch is incomplete. I assumed he was done. I'll get back to you later. if I have time.
so there should be basically no problem to implement an automatic 2-way communication. i will finish writing the code and do an experimental setup. incidentally, the cc1101 has an internal...
hello, unfortunately i haven't found the time to complete the sketch. because I worked on the 2.5.0 update. It is now possible to use the internal crc calculation of the...
Hi, I've got it going this far. I approached it a little differently. It definitely works fine for me. I divided the battery voltage into 2x 8bit. the receiver then...
that is very unusual. unfortunately I can only test later. since i'm still working. with me it starts sending immediately after waking up. I use arduino ide v 1.8.9. I...
i used pin 3 for the button. with 10k pulldown resistance.