tjaychen

Results 27 comments of tjaychen

[uart] Convert edge based interrupt to level

do you guys think this should be a backlog issue? It would be very nice to fix, but UART is pretty close to V3 already...

[uart] Convert edge based interrupt to level

actually...an interrupt change from edge triggered to status might be considered a major change if semantic versioning were to go through.. @msfschaffner

[spi_device] Add an event for unexpected host behavior

is this one still valid given the recent mailbox change?

[spi_device] Tagging for Upload Command/Address FIFOs and Payload Buffer

@a-will i think in terms of normal, valid commands, this is probably true most of the time. Especially since commands we want to upload / capture are "usually" going to...

[tlul] tlul_sram_byte data integrity check

@weicaiyang

[tlul] tlul_sram_byte data integrity check

o sorry, this is due to lack of a tagging scheme. This is meant to be "future" improvement. I'm not too concerned about weaknesses in the byte case because we...

[spi_device] Read Status, Read JEDEC ID, Read SFDP to have fixed value (read-only) in CMD_INFO

is this one still open @eunchan ? It kind of seems like it probably falls into future release category also

[topgen] Remove duplicated license headers from autogen files

ooops! this is my bad. I think it's probably a result of the ip level example not having that header (thus included in the template), and `topgen.py` having it. I'll...

[hw/kmac] Setup kmac for security verification and check for key leakage from keymgr port

ah i think this is really just a matter of verification, and it is indeed related to that issue (at least part of it).

[hw/kmac] Setup kmac for security verification and check for key leakage from keymgr port

@cindychip This is actually more related to the security tool checks where we can check if a signal leaks out in a specific way. Honestly though, I am not sure...