Anathema-Device
Anathema-Device
I have a similar issue and tried simple mods to let me push the PTFE further through with the hope that it would result in less friction but that was...
@michaelbeljaars I had a similar issue and I found that making sure that the top was smooth helped. Adding a tiny bit of silicon grease or printing the lockers in...
@michaelbeljaars I think if it is catching in the dip in the top of the locker then the locker may be too high? I also touched the top of each...
Make sure that the top and and the block below both have smooth, flat surfaces so that they mate cleanly and move smoothly. You could also remove the top hat...
I don't see why it would not work. You would need to think of a way to put the filament sensor near the hotend I expect. Hypothetically the tube lengths...
I wonder if it is actually necessary. I don't run a CW2 right now but after moving to the sensor-less version the ERCF has never been more reliable. So I...
It really is not needed, moving to Happy Hare V3 code to drive the ERCF makes the tool head sensor unnecessary https://github.com/moggieuk/ERCF-Software-V3
I've printed the ERCF of a sloppy Geetech A10M then reprinted some parts on a Voron 0 I have to say that this part is not one that I had...
No need for a filament sensor at the extruder, look for the Happy Hare code to drive the ERCF, for me it works better without the sensor