Vincent Poon

Pixhawk 6C only work with Daily Build

6

Pixhawk 6C was just released, but unfortunately it only works with the daily build, not the stable build. I am curious to see if new QGC release is coming soon....

QGC Shows "GPS Disabled" in Sensor Status

4

## Describe the bug Using Master firmware, flying with GPS in position mode was successful. However it shows "GPS Disabled" on sensor status. Not sure if this is a QGC...

New Pixhawk 6C ConfigBatteryMonitoring Not Working Correctly

1

#### Issue details This battery monitor setting in master/beta isn't working properly for HW Ver: 10: Pixhawk 6C/Pix32 v6 It would switch to HW Ver : 1: APM2- 2.5 non...

[Bug] Unable to Download Parameter into GCS in Mainland China

5

### Describe the bug QGC would get stuck at "loading" in Mainland China.  - The loading would resume if an VPN is used, or internet is disconnected. - Tested...

BMI270 PX4 Driver Support

7

BMI270 is a common IMU used in many flight controller such as the Kakute H7 v2. It would be great PX4 can support this IMU.

Add Holybro Remote ID Module to README.md

Add Holybro Remote ID Module

[Bug] FMUv6X with MS5525DSO Airspeed Sensor Not Working Correctly

1

### Describe the bug With the Pixhawk 6x + MS5525DSO Airspeed sensor, Master PX4 FW, the air speed went through calibration, but it did not require blowing into the tube....

Update rtk_gps.md Heading Info

1

Add unicore dual antenna heading

[CAN GPS] Dual F9P Heading Support for CAN GPS (Non-PX4 CAN FW)

13

### Describe the bug Using a Non PX4 CAN Node GPS, such as the Holybro DroneCAN F9P (Uses AP Periph). These Parameters that are required for CAN GPS Heading are...