microprint
microprint copied to clipboard
tomasf
Printing software for M3D Micro for OS X
Got my M3D micro yesterday and was appalled by their software. Coudln't get it to work. Microprint seems promising! For me, it doesn't work though: it gets stuck in the...
I used Cura 15.04 to make a model; however, Microprint didn't like it. Is there a solution to this issue? I've attached a screenshot below: 
Has any one else experienced printing gcode generated with the latest Cura 15.04.5 software? I am getting a code error. I reverted to an older version of now.
I have a simple script that notifies me by email when the print completes but MicroPrint throws an Apple Script Error -1708. The script runs fine on its own. Any...
Definitely more a "nice to have", but I pressed, multiple times, by accident on the next corner button during the bed calibration process...you you end up needing to start all...
Hey @tomasf, Thanks for the amazing software. When I start Microprint it tells me that my Firmware is untested (probably because I have an old firmware and haven't been able...
Two initial problems with trying to process gcode output from Slic3r: 1. The **G21** code is rejected (can be ignored) 2. Doesn't complete preprocessing (due to no Cura profile?) and...
Noticed the pre-processor is garbling the g-code here and causing an error to be flagged by the printer. Heating to 220°C: 95% - T:214.0416 Heating to 220°C: 97% - T:214.0416...
The code for trying to find US vendor ID's didn't work, couldn't find USBInterface. So I used a path matcher method instead. This seems to be the more standard way...