"Failed to parse G-code line: M117 Printing..."

Open RubiksCuberDude opened this issue 9 years ago • 3 comments

I used Cura 15.04 to make a model; however, Microprint didn't like it. Is there a solution to this issue? I've attached a screenshot below: screen shot 2016-06-20 at 1 42 02 pm

Jun 20 '16 17:06 RubiksCuberDude

Remove the M117 line from your start G-code in Cura.

Jun 20 '16 18:06 tomasf

Thanks for replying. I'm sorry for being a total noob, but I'm not too familiar about doing that. So when I tried, I got this error message: screen shot 2016-06-20 at 4 10 12 pm

Jun 20 '16 19:06 RubiksCuberDude

Ah! So I downloaded Atom, and deleted various lines until Microprint saw fit. It's in the works of printing now, and I think you sincerely for showing me this.

Jun 21 '16 01:06 RubiksCuberDude