G0 E0 cause "Too small" error

[scotty1024]

Noticed the pre-processor is garbling the g-code here and causing an error to be flagged by the printer.

Heating to 220°C: 95%

• T:214.0416 Heating to 220°C: 97%
• T:214.0416
• T:214.0416
• T:-1
• ok 19 Sending N20 G0 X35.378 Y31.658 Z0.2 F30
• ok 20 Sending N21 G0 E0 Printing: 0.04%
• ok 21 Sending N22 G1 Y30.7459 F185.5663
• Info:N:21 Too small Unhandled input: Info:N:21 Too small
• ok 22 Sending N23 G1 X36.45 Y29.5919 Z0.2 E0.19645 F563.33778
• ok 23 Sending N24 G1 X36.848 Y29.1629 Z0.2 E0.26944

This is the section of source G-Code

M109 S208.000000 M17 ;turn on the motors G28 ;Home G90 ;absolute positioning M109 S280 ;wait for desired temp

;Layer count: 33 ;LAYER:-2 ;RAFT G0 F4200 X35.378 Y31.658 Z0.300 ;TYPE:SUPPORT G1 F1200 X36.450 Y30.504 E0.19645 G1 X36.848 Y30.075 E0.26944 G1 X38.148 Y28.918 E0.48650 G1 X39.838 Y27.648 E0.75017

As you can see right at the beginning. The pre-processor doesn't seem to like that ";TYPE:SUPPORT" being where it is. :-)

Scotty