Mark B.
Mark B.
I used to do initial sync with 4GiB and then could actually continue to run on 2GiB for maintaining the block chain. Since 4.7.0 and 5.0.0, 2GiB is not enough...
This happened when code for NU5 was added. I expect the add memory starts when the daemon hits block [1687104], mined May 31, 2022 17:50:05 UTC+00:00. There were quite a...
Needs logs.
The Network Discovery settings seem to be tied to the detection if the services are allowed through the firewall. When you enable simplewall and let it turn off the Windows...
I haven't tested this personally, but I assume this is expected - Simplewall is blocking traffic. It sounds like you need to allow the service that provides NAT or allow...
It doesn't make sense. For simplewall/WFP to break the connection, it must be filtering something. If the problem is a kernel driver, then the process would be the "SYSTEM" process....
I attempted to test this and could not reproduce the environment. Windows 2025 Server. Hyper-V Role installed. RAS Role installed. VM-Internal Switch created. Static IP assigned. Enabled RRAS as NAT...
I re-installed and reproduced the issue using the same configuration I started with; something must have been off with my initial install. When simplewall is enabled, rules for NAT routing...
To add to this, when I enabled the Allow Windows Update rule on a Windows 11 23H2 system, it broke Windows update; the process could not start or entered a...
You need to post the detailed settings of the rule.