piotr-go
piotr-go
Couldn't the transfer be buffered? 2MB is plenty. As an experiment, I started writing my own print server.
> buffering should be either in Printer Firmware That would be the best, but the printer buffer is small. > Good that is nice project - you will see that...
> Does your sender do also Temperature / Position monitoring when streaming ? Sends all responses to PC, but they are ignored for now. > Also does it handle heating...
Success. I printed from SD card connected to ESP32-S3. ~32MB file printing time: - from printer card: 6h25m +-1m. - from ESP32 card: 6h25m +-1m. No difference in print quality....
Probably yes. But it will take couple weeks. I designed and ordered new PCB. For the prototype I used my internet radio ESP32-S3-MINI PCB. Final version (i hope :)) will...
Final version will probably have only wifi upload and stream from card. At least that is the goal of this project.
Print progress is available on LCD and will be available in web gui.
I can set high priority for the print thread. I am happy with just sending file over wifi + starting printing. This is already big improvement. If wifi print status...
GPIO18 and GPIO19 are USB pins. I found some crappy USB cable, no data lines, only power, and it's working :) Thank You. It appears that powering this module via...
From what I remember, you can set autodetection of PSRAM in the config.