Miguel Sanchez
Miguel Sanchez
Ever heard of Google? https://www.google.es/search?q=bresenham+flowchart&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwiVoYGrrrTPAhWC7RQKHS2lBkgQsAQIHQ&biw=1190&bih=682&dpr=1.25
Hi Star, The main memory eater is the array to be able to respond to S command. That may come in handy when tuning the PID but it is a...
Hi, 1) Yes, you can use this project to get closed loop control of a dc motor using an L298N. 2) My code uses an incremental encoder so you do...
ENDSTOP is an output you can ignore but STEP and DIR are input pins you can use or set to HIGH or LOW if you do now use them.
rst cause 2 is due to Reset button being pressed or chip waking up from sleep mode. None of it seems to make sense in your case so ... my...
You need to figure out which one of the listed ports COM3 COM4 .. COM11 is the right port for your arduino. Latter, on line 26 you need to set...
or you can just make portName="COM4"; On Mon, Sep 9, 2019 at 10:32 AM Miguel Sanchez wrote: > You need to figure out which one of the listed ports COM3...
Serial connection is established, not sure what is wrong with it. On Wed, Sep 11, 2019 at 8:21 AM SirGioVan wrote: > ys [4]. > Apenas asi loqre que se...
Thanks a lot @ghaz007 for your comments. I reckon you can remove the analogWrite from your L298 code entirely. And those that write a 0 can be replaced by digitalWrite(M,LOW);
Hi @bogus105, Please take into account that ESP32 is a much faster processor than Arduino (and totally different architecture) so the Arduino macros will not work with it. What you...