Brad Downey
Brad Downey
Is it possible to use JWT to authenticate? I'm trying to use this in a pipeline and trying to keep my dependancies low. I have a JWT injected into my...
### Describe the issue you are experiencing Memory is bouncing off 100%, normally over 90% and hits 95%+ a lot (I setup an alert). Power cycle is required. I can...
I'm struggling to find a way to configure an alternate uri for `jwks_uri` in `.well-known/openid-configuration`. I have read [discovery_url_options](https://github.com/doorkeeper-gem/doorkeeper-openid_connect/blob/master/README.md?plain=1#L166) and found that I can change some things but not the...
California Camp Grounds are in high demand and I'm looking for a way to get alerts when spots open up. California uses a separate system at https://www.reservecalifornia.com I would love...
Device like: https://www.amazon.com/dp/B08Y59HDSQ "product_name": "Water leak sensor " `[11/02/2022, 18:04:38] [TuyaLan] Ready to handle Water Leak Sensor (SimpleLight:3.3) with signature {"1":"normal","4":100}` "1" = no water detected "4" = batter percent...
Sometimes I use devices only for a period of time, like plug controllers for Christmas lights. Then they are offline until the next holiday. Obtaining the device id and local...
Device Like: https://www.amazon.com/dp/B08YRKLHLD Temperature and Humidity Sensor (WiFi) `[TuyaLan] Ready to handle Temperature Sensor (SimpleLight:3.3) with signature {"1":232,"2":40}` "1" = temperature in C x 10. Example is 23.2 C =...
I'm getting a TypeError when trying to scan GoControl HUSBZB-1. Scan fails, the flash seems to complete, but still unable to see anything on zigbee2MQTT. OS: Raspbian GNU/Linux Buster (10)...
### Description I installed a Filament Runout Sensor and it's working with your firmware great! However in the process of setting it up, it was hard to know if it...
It would be great to use this on a Mac as I cannot find any software that runs on Mac. It appears that pyudev does not run on Mac OS,...