jimkazmer

It isn't a bad feature... but I'd need a dShot command to indicate a reset (to avoid the power cycle), and maybe a status indicator that the ESC/Motor has triggered...

I tried turning OFF current protection... same behavior (stall condition deactivates ESC/motor). I changed the firmware back to 32.9 (from the 32.91 beta)... same behavior (stall condition deactivates ESC/motor).

I tried the settings shown below, and it happened quicker than ever, with the least force required to stall the motor. 

I have a competition this weekend, and need to use these ESCs (I do not have enough of my old ones). Any insight about how to avoid the issue (via...

Here is a video showing the problem: https://youtu.be/aultj1uf7qI I changed my ESC settings to the ones that made it the hardest to reproduce (shown below). The ESC/motor on the left...

The "loaded startup testcode" does not have firmware files that match the RDQ and TEKKO firmware files I am using: - RDQ_32_Bit_AT_Multi_32_91.Hex - TEKKO32_F4_Multi_32_91.Hex I'm not sure what to use...

That code did stop the "ESC/Motor deactivation" (on both the RDQ and TEKKO ESCs). Thank you! I heard the squeal, once out of many tries, while I was still holding...

Does the slower acceleration persist at higher motor powers (e.g. 40%, 60%, 80%)? Does "Rampup Power" or "Maximum Acceleration" config settings (or any other setting) affect the rate of acceleration?...

Hi. I recently implemented the telemetry request via dShot on the teensy (an arduino like microcontroller). I received back the documented 10 bytes. Something that was documented, and that I...

I too am trying to use "auto-telemetry". Our situations may be different. I am trying to use auto-telemetry with dShot using bidirectional flight mode settings. What I recently learned is...