jaarsa

Try adding the following (cus 127 nor locahost works) http://ip-address-of-tvh:9981 Where "ip-address-of-tvh" could be ie. 192.168.x.x or what ever ip-adress TVH uses.

Try adding to line 163: video_resolution=1080, video_codec=VideoCodec.H264, #audio_codec=AudioCodec.AAC, Outcomment the audio part if you have no sound. Also look here for pic. http://prnt.sc/cisgci

> Thanks abaghbani! > > It was probably not the smartest idea to hide the log in the linked spreadsheet: > > In the screenshot is only the "PROG", but...

You could try to change pin8 (GDO2 - RX interrupt) to GPIO14 as long as you follow the rest of the shcematics. That means you keep pin 3 (GDO0 -...

You can check out this https://github.com/rstrouse/ESPSomfy-RTS/issues/603#issuecomment-3393611586 to see why you should avoid GPIO-12.

Hi, and thanks for the fantastic project! While setting up ESPSomfy-RTS on the **LilyGO T-Internet POE** board, I noticed that the current recommended pinout includes GPIO12 and GPIO15. These are...

Can you post a picture of the board, with the pins connected? If you use GPIO12 you might get problems. Why Using GPIO12 Can Be Problematic: GPIO12 is one of...

Avoid using GPIO12 for RX/GDO2 if you experience boot issues or sluggish performance. Alternatives: Use GPIO4 (pin5 on the right-hand side), GPIO14 (pin5 on the left-hand side), or GPIO27 (pin6...

GPIO 12 can be a bit sensitive during startup on some ESP32 modules (it's used for bootstrapping). If you encounter issues during boot, consider moving GDO2 to another GPIO, such...

@G-eos Did you manage to change the pin, and did it work out for you?