Emerson Corder
Emerson Corder
Has the fan and BLTouch issues been resolved?
> Im still facing the same problems even with the latest Marlin configured with Soft PWM on too, > > Any one have any luck and fancy sharing a build...
I was hoping for the same. I really want to use this or the 280 for monitoring the Humidity and temps in my printer room, and want it pooled up...
I'm asking the same. I put the code in via the raw code editor and nothing comes up
Hope this is the write thread to ask in, but would the Raspberry Pi Zero 2 W be capable of running this?
As far as I know, theres no 2240 driver support in Klipper yet
I corrected the issue by putting a 100ohm resistor on the data line just after the board. Lots of noise ends up on the data line which causes issues, the...
When you compile the firmware for the board, are you choosing USB or serial connection? The M8P & CM1 uses the USB connection option.
> I would like to have an overview of the Pin Numbers for the M8P board. Some are in de manual, But others are missing (Uarts for example) Some I...
Having the exact same issue with the same setup (x-endstop on the EBB36)