deHarro

Adapter board for a display (obvious from SIEMENS LOGO!), sold at Pollin. It carries an Arduino Nano V3 and an I2C adapter on one side and the display on the...

Another project I made I already posted here, but to keep the pictures together, here again... It's the controller board for an [electrically boosted city scooter](http://www.harald-sattler.de/html/e-roller.htm) (in german). The design...

Hi all! Since I always sit by and watch the milling process and don't want to get my working area spilled with dust, I use a vacuum cleaner with modded...

Hi sirsenor, looks quite good :) Do you remove the solder mask with a spring loaded stylus or just made another pass with the engraving bit, adjusted somewhat higher? You...

Very clean, congrats!

Fine! Recently (somewhere?) I saw one using a spring loaded stylus to scratch away the solder mask from the pads, again using the router. If you find an easy to...

I found this tutorial https://www.all4hardware4u.de/platinenherstellung/platine-verzinnen/ It's in german, but perhaps you get the point. He uses a chemical that is used by pipe-fitters to solder copper tubes for water or...

Ok, I'll test it with the new release. It's not there already, isn't it? Harald

Ok, kein Ding :-) Gruß Harald _______________________ Modellbau&Elektronik www.harald-sattler.de Von: Martin Pittermann [mailto:[email protected]] Gesendet: Samstag, 25. April 2020 09:25 An: martin2250/OpenCNCPilot Cc: deHarro ; Author Betreff: Re: [martin2250/OpenCNCPilot] Save/Restore Viewport...

Hi Martin, I'm so sorry to tell you... it still occurs. I'm not able to get the initial sequence to make it happen, but if I got the 180° flipping,...