Jay Jaeger
Jay Jaeger
The Micropolis hard sector decoder is only correctly decoding about 1/3 of my Mod I disks (35 tracks, 48 TPI). I haven't tried the Mod II's much yet, but from...
I captured a .scp image using a greaseweazle (V0.27) using this command using a Micropolis 1042 mod I (SSDD, 35 tracks, 143KB total capacity) gw.exe read --drive 0 --rpm 300...
Rather than referring to the part you connect to the PC as "the blunt end" I suggest you say something like: Plug the end of the PSoC Fluxengine board that...
I have a little script for my Micropolis drive which is set up to capture an image file, and also a copy of the flux in one command, to minimize...
I am working with Micropolis drives with a very very slow step time (30ms track to track, 10ms settle). It would be nice if I could control that. As it...
[Updated 8/28/2021 to reflect details on the signal lines.] I have run into an issue trying to use my Micropolis drives with my new fluxengine. I have seen two symptoms:...
Stopping a fluxengine read command mid stream causes things to be very confused, to the point where I have to disconnect it and turn off the drives and then connect...
I originally reported this issue on launchpad back in 2014. Today I received an update that directed me to report the issue "in the appropriate GitHub repo". So, here I...
The Link to Icarus Verilog in Readme returns Error 404. I managed to find it via a search, but thought you might like to know.
The reason you had trouble dynamically configuring the PHY using the strap pins is that the chip is not designed to do that. The strap pins are designed to *only*...