bearclaws8

Do we need a separate issue to track MMU3 capability or can we use this issue to track both? If we can use this issue to track both, can/should we...

I have run into the same/similar issue with the printer not starting a print because it had a notification on the screen indicating that a new firmware update is available....

Having the ability to modify the passwords and/or completely disable the need for passwords would be a great enhancement. I was hoping to install Prusa Link on a completely dead...

Possibly related. Would a print job from PrusaLink have the ability to recover after a power outage the same way printing from the local printer SD card does? If not,...

Is it possible to not require the printer to be rebooted every time the pi with Prusa Link is restarted? When trying to install extra packages or additional hardware (e.g....

> Hi, I have experimented with disabling the reboots temporarily, but that just puts a lot of extra wear on the eeprom in the usb communications chip. You can disable...

I wanted to add a bump to this item. Having preheat presets consistent with what we're used to in the printer would be a great help.

I am going based off of the wording Prusa uses in their installation steps, which says: > PrusaLink verifies your printer's serial number with Prusa servers Looking at the instructions...

@TojikCZ Thank you for the clarification. It is unfortunate it was an oversight, I hope it can be modified in future versions before the software reaches v1.0 (maybe at the...

I was able to verify that I could get a printer connected to PrusaLink and successfully upload a file and print on a network completely disconnected from the internet. The...