TommyC81

I'm observing the same as well, ideally the settings should be stored proper. Also to note that the indicated XPRESS8K is not selected by default, it is always XPRESS4K selected...

From my experience, the software does not take into account whether the file is already compressed. It re-compresses again despite using the same algorithm.

I'm experiencing the same - 1/4 Waystones are unnamed. I'm also unable to rename them. I get the menu up to adjust waystone things when shift+right-clicking, but it won't accept...

Thank you, the option is selected. The help-text mentions that "...it can go as high as +50% for infill in very small areas where rectilinear doesn't have good coverage)...". Could...

E-value is tuned on the printer, extrusion multiplier is 1. Getting perfect output except in the small infill (and Gap Fill areas). With "Solid infill overlap" at 100% I get...

Thanks! Yeah, I gather it can get complicated as the area sizes can be mixed and run into (very) different considerations for the same settings. I'll try with those settings...

Thank you! So, I did a quick run with the 30% distribution and 100% width (infill: ironing). I also re-set "Solid infill overlap" to 100% to do it fresh this...

> > To check; changing ironing distribution and width setting will also affect the top infill then (I gather)? > > Only for the ironing pattern (don't have an effect...

I will try another piece, with a slightly adjusted test piece to see what comes out of it. Note that I've reverted all settings to 100% infill/gap fill again, just...

UPDATED to reflect that there actually was a little over extrusion on the first layer in the black and red circled areas. Outcome: First layer looks good overall, smooth with...