SkiBikeMake VT.548 comments

Repositories
Issues
Comments

Results 3 comments of


                                            SkiBikeMake VT.548

Add clearance for bearing in Selector Encoder Cart

> that's an idea, but that part there is overextruded AF as well Maybe slightly overextruded as there is only 0.2mm clearance in the nominal design clearances and the bearing...

Encoder cart tolerance/clearance issue

Hi Jeremy, I submitted a pull request. I have never done one before so don't know if I did it right. Although I created edited STL's I don't know how...

Filament and tube generate static electricity then cause mmu board been shock and disconnect. (Potential damage)

I can confirm this is a legitimate issue as I experienced this multiple times back when I used the ERCF EZ board. As an electronics manufacturing engineer, managing static electricity...