RaccoonAD

Results 5 comments of RaccoonAD

Getting the error terminate called after throwing an instance of 'std::runtime_error' what(): Could not configure serial baud rate

Yes, here it is: # Configuration Settings for ZED-F9P device debug: 4 # Range 0-4 (0 means no debug statements will print) device: /dev/ttyUSB0 #tmode3: 0 frame_id: gps uart1: baudrate:...

Getting the error terminate called after throwing an instance of 'std::runtime_error' what(): Could not configure serial baud rate

Yes, I tried it before cause I saw it in another issue but same happens.

Getting the error terminate called after throwing an instance of 'std::runtime_error' what(): Could not configure serial baud rate

Do you know something else that I can try?

Getting the error terminate called after throwing an instance of 'std::runtime_error' what(): Could not configure serial baud rate

Yep, but I'm currently obtaining another error that says failed to poll mover and set relevant things. But if I use screen on ttyusb0 everythings seems fine. I don't know...

Getting the error terminate called after throwing an instance of 'std::runtime_error' what(): Could not configure serial baud rate

16.04