Tim Long
Arc Welder doesn't appear to process arcs when spiral vase mode is used. For example, a simple cylinder printed in vase mode will produce arcs in the skirt and initial...
**Is your feature request related to a problem? Please describe.** Flow rate is best set per roll of filament. The recommendation is that for each new roll of filament, flow...
## Current Behavior I have the following equipment: - RadioMaster TX16S with HappyModel ES24TX Pro module - Diatone Roma F5 quadcopter running Betaflight 4.3, with HappyModel EP1 Rx - Custom...
## Current Behavior There seems to be general weirdness around the handling of barometers that use MSP protocol. I am using the Matek M8Q-CAN GPS/Mag/Baro unit. I'm not using the...
Version: gyroflow-0.3.0-beta When attempting to render using the h264_nvenc encoder on a GeForce GTX 960 in Windows 10, I get the following error: ```lang=log Output file: F:/[...]/ISAW0043_3D-Smoothed-nvenc.MP4 Using ffmpeg path...
I know documentation is a dirty word in the open source community, but the Should* extension methods could really benefit from some IntelliSense support in Visual Studio. I know I'm...
In principle, this effect is great but it doesn't seem to work. I have it configured like this [...] [neopixel chamber] pin: P1.24 chain_count: 144 initial_RED: 0.031 initial_GREEN: 0.031 initial_BLUE:...
I've been trying to put `Restup` to use on my Raspberry Pi 3 and I'm having reliability issues whenever I try to return any content e.g. for a Get request....
Note: I tried to bring this up on the Octoprint forum, but despite insisting on me giving "as much information as possible" I was prevented from posting because "new users...
## Current Behavior I have observed this issue on two different models both running Betaflight 4.3.1. I set my VTX power using the 6-way switch on my radio. I will...