Gabriele Russo
Gabriele Russo
> That's a secondary feature for systems constrained by battery current. Imagine a motor that can flow 400Apk but with a battery rated for 50Adc. In those cases at very...
> > simply use the same current fro battery and phase and you will get almost the same response on the complete rpm range of the motor. > > If...
During pid tuning I noticed that motor demeanor isn't very linear during real usage under load. So you may get good results during open loop testing or bench testing with...
you can try to change the motor poles to try match the other motor
> The newer heltec tracker model v1.1 has a different power logic. AFAIK it's not possible to switch off the screen without also switching off the LoRa chip. It is...
i don't remember having this problem, both disabling it via settings and via triple button push. Are you sure it's not the last known location?
> It does appear to have a 'last known location' stored in the fixed position values, but it continues to transmit this as a current location, even though 'Use fixed...
I just tried it, it does happen on .22 and from what i remember it does happen on .19 too, on reset i get no location in the device and...
> Maybe things have changed in .22 - I might try that later. For reference, I also have a Heltec V3, which does have a fixed position enabled. This position...
> Just now, on my Tracker, I enabled GPS, and allowed a few position updates. I then disabled GPS. Following the reset, the last known position seen then appeared in...