Ben aka PE2BZ

Hi, have not seen any reply to this problem, which has been around for several months now. Been trying to debug this, but the parser logtail shows no errors for...

Hi. If I set the squelch to auto the OpenwebRX PC says: [openwebrx-httpd:ws,0] command: SET squelch_level=3.162277660168379e-7 So, in plugins/dsp/csdr/plugin.py I edited the line self.squelch_level = 0 to 3.162277660168379e-7 Now, when...

Hi, Can I add to this issue that for me (SI-5351A-B-TG) the same problem occurs ? When running an oscillator.ini which does not use any libray but writes to the...

I hope you find the time to take a look at this issue. Still no luck to get it to work at 144 MHz. Thanks, Ben

I can add to this issue that with Ubuntu 20.04 lts in wsl 2 I run into the same problem except for me the problem appears as 100 percent, docker...

After "can not connect to target" I have to remove a battery, disconnect the programmer, put it back, after which the sonde starts. Might work for you too? Op vr...

Hi Robert, sorry for my incomplete reply but I had to go for work and tried to send you a solution for the "bricked RS41". In short: I did not...

[bz-config.h.txt](https://github.com/mikaelnousiainen/RS41ng/files/9938315/bz-config.h.txt) Sure, Has V2 on SI4032 enabled, has V2 and FT8 on SI5351 enabled. FT8 transmits but as shown on the waterfall it cannot be decoded. Thanks, Ben

Hi Alexander, thanks for your reply. Caught by the flue it took me some time to react. Sorry Tonight I succesfully prepared my own radio_config.h for 144.3375 MHz . I...