yq3w

>  Hello, where can I find the driver for IMx283?

Yes, I used your method to capture images correctly on cm4, but after I redone the system on pi5, there was an error message (imx283): RuntimeError: Unrecognised raw format RGGB16_PISP_COMP1

 Thank you very much for the quick response. My Raspberry Pi ultrasonic transducer is used for learning purposes. One is responsible for transmitting and the other for receiving. The...

Thank you for the HC-SR04 information. I have gained a better understanding of how to send pulse signals. The Echo pin seems to only read 0 or 1. I did...

 I want an intuitive 2D diagram like this, is one transducer not enough?

There are three test pins on the Lucky Fish Finder circuit board. TS1, TS2, TS3. Through the oscilloscope, I think TS1 is a pulse signal, TS2 is the original signal...

 This LE5010A1 is an MCU with Bluetooth


 I just bought an Arduino Uno R4 from an online store, and also bought a Arduino expansion board of cm4. The introduction shows that the GPIO function is the...

 The red component should be a high-frequency booster, because the circuit becomes wavy after passing through it and the voltage is very high. The oscilloscope shows that it is...