Willem van den Akker
Willem van den Akker
Hi, Try to send with a delay (Advanced Configuration).Start with 1ms. /Willem On Tue, 2020-09-15 at 19:42 -0700, Jacques wrote: > I try sending a raw file but the process...
What is the size of the file? I can send 300kB without any problems. Did you start with 100ms? Or went up from 1 to 100 (in steps)? On Wed,...
@m700ace or @Picatout What kind of file do you use? ASCII/Binary? Perhaps you can post an example. As earlier mentioned I can send 300kB without any problems.
@m700ace,@Picatout It is possible to do a little test with socat? Run `socat -d -d pty,raw,echo=0 pty,raw,echo=0'` This gives 2 pty's; N and N+1 In another terminal run `cat <...
Can you post the file you transfer? I did a test with 50k ASCII and also 13k binary. No problems.
Hi, Thanks for the information. Which options do you use when uploading the file? Are you using flow control? If yes is it possible to test it without? If you...
Hi, Can you give me the exact file size of all files and position where it stops? If the transfer stop do you get a 'Error sending file' message? Or...
Hi, was there any progress on this PR? I am converting to gtk4 and want to drop the parsecfg part. Unfortunately I don't have a config file with macros :)
Agree, We can dump parseCfg and provide a tool to do some kind of migration. We have to find a solution for the macro's. But how hard can it be...
Ok, I gone dump the parsecfg and replace it with GKeyFile. On Tue, 2022-06-28 at 11:49 -0700, Florian Euchner wrote: > > We can dump parseCfg and provide a tool...