wlayher
wlayher
@sobo82 I have a nesting-cam with MotionEyeOS and a Longruner IR-Cam on a Pi Zero since last spring. I use a bh1750 sensor via gpio pins on the Zero to...
Flashed the image, restored from backup. - After enabling I2C and SPI via raspi-config, plugin WS281x LED Status is working. - Raspberry Pi 4 Model B Rev 1.1, 4GB -...
I closed all the browser tabs for the OctoPrint instance, then rebooted the Pi via ssh, let it sit idle for 69 minutes, then I opened the browser tab again...
You need a backup zip file from a **previous install** to restore from a backup. When you select "Restore Backup?" there will be a button to locate a downloaded zip...
My guess is that both branches are incompatible then. I had backups from previous systems with the new camera stack and that worked fine on my two updates. What branch...
So nothing happens after you clicked on "Restore Backup?" Strange, I did this twice today and there was no problem on both.
If I recall correctly, I directly clicked on the link "Restore Backup?" under "Start" on the wizard page, not on the button "Next". After that a selection dialog appeared where...