willie013

Do both the CN-CNT and CN-WLAN port use the same JST-PA 5 pin connectors? And on what port is the default wifi module connected on the latest Panasonic AC, so...

Thanks @Uro1 ! I will be getting 2 Panasonic Erethea units installed next week, so I guess I'll just open them up when they're installed and figure out which ports...

Hi @Uro1 , I opened up the installed AC, only connector I could find was this one:  But there's no indication if this is a CN-CNT port or anything...

@NikolasE I am facing the same issue on my setup w.r.t. the position of the laser scan, did you solve this in the end?

Any update on this? I am experiencing the same issues

I think the panasonic interface doesn't provide this information, and the estimated energy consumption has quite a delay on it to detect this. Using an external power monitor plug might...

That's great news @redbullterror ! However, I've been thinking about this: We need a way to predict when the unit goes into defrost, since when it enters the defrost state,...

Hi @redbullterror, I finally found some time to implement the defrost state. I made a PR for the original repo, or you can use mine to expose it. Just tested...

Great work @CSchlipp ! I will add that a offset might works, but the temprature sensor is just unreliable. Ideally the temperature sensor used to control the heating of the...