Kusuma Ruslan
Kusuma Ruslan
Hi altnelu, I don't know ramps4due, but i think it's possible.
Hi, I don't know what is NAN, maybe you enter a wrong parameter. About the slow motion, i have not solve that one too. Maybe because the calculation from cartesian...
You can find calibration guide txt in this github repo. I'm using finding radius of a circle using 3 points method. Rotate the angles and mark the points on a...
It saved in eeprom. You have to change eeprom using repetier host, or you clear eeprom using arduino ide example. On Sat, Oct 20, 2018, 17:22 gabriel13luca wrote: > HELLO...
Maybe there are some settings in simplify you have to look at On Wed, Oct 24, 2018, 23:48 gabriel13luca wrote: > Hi Again. I am finding difficulties to work with...
Hi, if your hardware are not in the firmware, you have to modify pins.h file to fit your hardware
You need the driver for your computer to connect to your hardware. If you can upload the firmware to your hardware then you already have the driver. You need to...
I think your problem is in configuration You have to recheck your scara is single or double arm. Then you have to check your endstop position is in min or...
According to your drawing, you calculate the x angle in the wrong direction. You are suppose to always calculate angles counter clock. You x endstop is in your x max...
both shoulder and elbow calculated counter clockwise