vonfinck

Results 7 comments of vonfinck

Best practise to troubleshoot for signal ---> No Idea if I did set it up wrong or if my DMX broadcast is not working

Hey, BIG fat thanks already for the help! Setupup wise: Exactly like you put it. I am seeing now finally an output ;D DMX: Univ: 0, Seq: 0, Data (512):...

Best practise to troubleshoot for signal ---> No Idea if I did set it up wrong or if my DMX broadcast is not working

I am getting further and further ;D Though the DMX decoder does not yet recognize the signal. (the DMX Control led is not turned on and also it does not...

Best practise to troubleshoot for signal ---> No Idea if I did set it up wrong or if my DMX broadcast is not working

Hey i think somewhere I am loosing power or the wiring is wrong ;D. The Max485 also gets pretty hot. (untouchable hot) I have setup more dmx fixtures, so that...

Best practise to troubleshoot for signal ---> No Idea if I did set it up wrong or if my DMX broadcast is not working

Alternative wiring I just tested ;D but no success... ![Sheet_2](https://user-images.githubusercontent.com/43039445/221264887-b72842a4-9000-43ee-8b95-375ca1de7f4f.png)

Best practise to troubleshoot for signal ---> No Idea if I did set it up wrong or if my DMX broadcast is not working

Hey, I got the somewhat jumpy signal output to work. I think the Max485 did had a short, like you said. It looks a bit like the signal is collapsing...

Best practise to troubleshoot for signal ---> No Idea if I did set it up wrong or if my DMX broadcast is not working

@rstephan THANK YOU for the support! I could not have done it without. I have now finally a working setup and will deploy it to the larger installation on Wednesday....

Best practise to troubleshoot for signal ---> No Idea if I did set it up wrong or if my DMX broadcast is not working

Hey Stephan, I think it was a mix of that. I have in the last run replaced all jumper wires, new max485 module and re-wired the dmx decoder connection. The...