Vassilis Bourdakis
Vassilis Bourdakis
hello Timo, since I have three individual compartments in my boat and three float switches and pumps with three controls on the lower helm (that I'm often not using...) I'm...
good morning, trying to get my DSM250 display to "communicate" with a teensy3.5 as far as switching relays is concerned. Teensy sending PGN127501 sent every 15secs (as per the Maretron...
> Good. So if you accept MIT, I'll send CANBOAT guys information of those PGN data structure. > > _Originally posted by @ttlappalainen in https://github.com/ttlappalainen/NMEA2000/issues/137#issuecomment-544108491_ > good evening Timo, started...
Timo, any idea how this PGN is laid out other than the OpenSkipper xml file? Garmin are happy and show fuel flow using PGN127489 but Maretron DSM250 wants PGN127497 :(...
hi, made a mistake somehow and gave the following values in the Vessel Base Data: Length 13 Beam 4 GPS Distance from Bow 3 GPS Distance from Center 4 Note...
small one, battery onboard, BlueSea disconnecting it form loads/charging. controller powered from the main el.panel onboard which takes power now from the existing battery (not even sharing GND with canbus...
hi, When setting up diyBMS it comes with 18650 battery profile presets. Whoever uses fe lifepo4 must edit all rules/balancing etc values. OK, you edit once and assuming you have...
@stuartpittaway we've (vaguely) discussed that before in another thread on the forum without a final conclusion (I think!). Anyway, I'm now trying to finish off the installation by connecting the...
hello, I'm trying to use orangkucing's teensy3 fork on a teensy3.5, IDE1.8.7, win10 I eventually got it running, but interrupts are really all over the place. Since I cannot open...
hello, long time, everything works more or less fine, except for two issues. I'll address the one here, the other in separate thread: I have: 3 teensies 3.5/3.6 one on...