Tom Lafleur
Tom Lafleur
Here is my code that works for OTAA mode, has been running for a few months... you need to change the APPEUI and DEVEUI to match your application on TTN....
I highly suggest you move on to MCCI version as the this basic LMiC code is no longer supported and is way out of date. You may also want to...
RFM95 use a standard xtal, at these SF, frequency accuracy is very important, if the xtal has drifted due to age or temperature, the radio often finds it hard to...
You need to show the error, processor use, ver of ide,,,etc, etc.... On Tue, Feb 18, 2020 at 6:18 AM jbrepogmailcom wrote: > In example code ttn-abp, I get error...
RFM95 connect via SPI serial and 2 I/O lines to DIO 0 and DIO 1 on the RFM95 On Fri, Mar 6, 2020 at 12:09 PM Percmau wrote: > Hi,...
I believe that the SX1278 is a ~433mhz(140-512MHz) version of the LoRa chip... should work just fine if the correct pins are wired correctly... ~~ _/) ~~~~ _/) ~~~~ _/)...
First of all, this software uses a bit-bang soft-serial port using any GPIO pins, it's NOT connected to the UART on the ESP8266 as the UART is connected to the...
useing an esp32, works just fine.... ~~ _/) ~~~~ _/) ~~~~ _/) ~~~~ _/) ~~ Tom Lafleur On Sat, Jan 1, 2022 at 2:53 PM Greg Smith ***@***.***> wrote: >...
I believe so, will need to retest
Terry: I noticed in the current version 2.3.1 of your LMiC code that you have an example: ttn-otaa-network-time I take it needs some additional code at the server to function??...