trenth00
trenth00
> We have not yet published it because HW require a long time for approval of new codes. So for the meantime I've put testcodes here: https://github.com/bitdump/BLHeli/tree/master/BLHeli_32%20ARM/Misc%20testcodes Is there any...
Thanks. Where do I place the test code under the MACOS version of BLHeliSuite32? Edit: ignore that, I figured it out
Would be great to get this feature to enable easy access to high performance Mags such as RM3100 without having to provide explicit device support. We have it now working...
> We have sent M10Q-5883 and CAN-L431 samples to some BF devs in last Nov. CAN-L431 node with AP_Periph fw supports GPS/Mag MSP output if connnecting it with M10Q-5883. No...
Yep its not a hardware thing as it works well under iNav
@haslinghuis can I please ask you to reconsider this issue as I have just found someone else with exactly the same problem, however in his instance it was with a...
I'll give these tests a crack, but I am no expert when it comes to electronics. So to confirm: - to measure voltage on SCL & SDA pads, I just...
@ledvinap I managed to get some measurements during a failure. -SDA voltage = 3.27v -SCL voltage = .03v -Softreset (from configurator) made it work again. It's actually quite hard to...
> Can you measure voltages after unplugging M10Q-5883? Now this was extremely tricky. as the connector is soldered onto the board ( and I cannot get the multi-meter probes into...