tigers75

Bubbles not showing randomly

11

It happens quite often that the bubbles disappear (I think they become very very small in fact), like in this image:  This happens **ALWAYS** while and right after...

[BUG] some lines not connecting properly to bubbles on some resolutions

2

**Describe the bug** On some resolutions the lines don't connect properly **To Reproduce** show the card on mobile app **Expected behavior** lines should connect to bubbles, there's a little gap...

**Is your feature request related to a problem? Please describe.** There's some bubbles that have a zero threshold tolerance, a value under which the connecting line is not shown. This...

Can this be used with MQTT thermostat?

4

## Describe the bug If I try to setup the awesome thermostat with an MQTT climate I get an error, since it does not accept the "platform" property. Is there...

I'd like "motion delay" to work both ways

1

**Is your feature request related to a problem? Please describe.** I have a room that has an entrance so I don't need it to be instantly warmed up everytime there...

Pop up doesn't auto-close in non focused-window

9

For any feature request you can open a new discussion here: https://github.com/Clooos/Bubble-Card/discussions/categories/feature-requests For any question you can open a new discussion here: https://github.com/Clooos/Bubble-Card/discussions/categories/q-a **Describe the bug** I have an autopop...

Better icons in landscape orientation

1

**Is your feature request related to a problem? Please describe.** When the phone is in landscape mode the widget icon get very small, almost unreadable. This is in portrait (I...

Can't use slider in pop-up on mobile in 3.0.4

1

For any feature request you can open a new discussion here: https://github.com/Clooos/Bubble-Card/discussions/categories/feature-requests For any question you can open a new discussion here: https://github.com/Clooos/Bubble-Card/discussions/categories/q-a **Describe the bug** With version 3.0.4 (3.0.3...

I have setup the IRHVAC and everything works fine, except that some command (the ones correlated to swing) are not interpreted correctly by Tasmota-ir: when I sent the command "start/stop...