Mike Szczys
Mike Szczys
Thanks both for the help. This gets me closer, but I'm having trouble waking my display. I checked one of the coin cells with a DMM (no load) and get...
Thanks for the help. Still not working but a bit more progress. I took batteries out and powered from bench supply at 3.0 V. I played with frequency settings and...
It's an AliExpress special and should be 868. I ordered 2 and should try the other but perhaps I need a module of better provenance. 
Great work @xsrf -- I was able to get this working with 0x0F
Just a guess here, but can RSSI measurements be used to judge the effectiveness of the offset value?
I've tested this and the new settings work well, nice addition! I have noticed that my RF module drifts. I can always activate a display with the offset of 0x0f,...
Here is a picture of the silk on the rear side of badge. We can note this quirk in documentation once it's decided what the best resolution is for the...
I got hung up on the missing MDNS.update() command needed to make this work. This pull request should be merged as it fixes the problem in the code examples. I...
You may be right. I experience a similar problem. After I program the chip (using OpenOCD) it runs just fine until I press the reset button. This causes it to...
I couldn't figure out a way to do this. I ended up using the following workaround: 1. Run commands to set up the tmux line the way you like it...