David the Swarfer

Here is a SketchUcam file with tool changes. This is created by generating a file for T1 and another for T2 and then using the joiner tool to join the...

Note the Sketchucam can also insert a macro for the toolchange which may not include a M6 command. User beware (-:

yep, just look in the file. the joiner hooks a few lines from the comment header of each file and includes them in the output just before the tool change...

> > > @swarfer : > > `Here is a SketchUcam file with tool changes. This is created by generating a file for T1 and another for T2 and then...

Hiya short version : you can remove the arc output formats. long version: all the number outputs should be the same length and have to be longer than you think....

yes, it was always failing for me when X or Y was omitted if memory serves. but one failure among many arcs still has the same solution = always output...

Hiya Here are the 2 designs This one generates faulty arcs along the edges of the ovals https://a360.co/2LAWq08 This one generates faulty arcs in the small slot https://a360.co/2NUDVjM

still not connecting [18:44:48] [ connect ] PORT INFO: Port is now open: COM7 - Attempting to detect Firmware [18:44:48] [ connect ] Checking for firmware on COM7 [18:44:48] [...

nope, Pico comes up as COM7 and CONTROL reports [06:52:15] [ 3D Viewer ] WebGL Support found! success: this application will work optimally on this device! [06:52:16] [ websocket ]...

i have now changed settings ($15 and $14 IIRC) so it does not boot in alarm state and now I see 'error:2' after connection fails. bCNC still 'just works' though...