Sebastian S.

@ngardiner the setup script of dbus-mqtt-devices [appends](https://github.com/freakent/dbus-mqtt-devices/blob/main/bin/setup.sh#L33) his line to `/data/rc.local` For me everything is working new. But just to be aware that this can happen.

Yes. I would like to use your Rpanion-server as "Rpanion-Broker" on the ground. I'm sorry if this feature request is to far from your idea what Rpanion-server should be. Scenario:...

The dbus-mqtt-devices driver works that way that you have to send to the `device//Status` topic to register a device. I would recommend to send the appropriate massage every minute from...

How does your Arduino device detect if a deviceID disappears? Tasmota would have to check if `W//[...]/pvinverter/` is present. Most of the Tasmota devices are ESP8266 based. These devices can't...

> * Manuel reboot of tasmota -> Worst solution, even if it is only once a year. @Hofyyy You mean: Manual reboot of **CCGX**?

Sorry, missunderstud the situation. I read "situation" instead of "solution". :-D

> On Mqtt disconnect you could just set the device Id to "". > > I looked at my Arduino code again just now. Despite what I said earlier,I realised...

Maybe we should 5sec after MQTT#Connect before we send the registration. ``` ON mqtt#connected DO RuleTimer1 5 ENDON ON Rules#Timer=1 DO Publish device/%deviceid%/Status {"clientId":"%deviceid%","connected":1,"version":"v1.0 ALPHA","services":{"wr":"pvinverter"}} ENDON ```

@Hofyyy, did you had a chance to test it? Was it OK with a 5sec. delay? Sebastian

I suppose the driver needs more than 5 seconds longer than Mosquittto to start after a reboot of the CCGX. That's OK or not?