Ties Stuij
Ties Stuij
Oh dear.. So I followed the guide by the letter. I cut the ribbon, did everything from the pi, etc.. For UC1, I still get the timeout error. For UC2,...
And here's a pic of my setup: 
Sorry, but I can't parse 'pinched'. You mean push down a bit on them? And yes, I omitted the writes. Everything got written correctly on UC2.
I guess you mean with pinching, to push them together a bit. So I pushed them together a bit, I pushed them out a bit, I carved up another SPI...
I would advice you Govinda to leave the electronics business and become a hand model while you're still young. Unfortunately I'm getting 'not-responding' errors whichever way I push and pull....
A wise choice in the long run I'm sure. My last resort is the prongs I soldered onto the UC1 programmer holes. I can desolder them and see what gives....
Very awesome!! Ok a few notes :) : - I think the ribbon cable you linked to is wrong. Or if it's not, it's confusing. That ribbon cable is a...
Oh and on the Arduino flash page the pics at point 5 and 7 aren't clickable, while especially those are nice to click just to get a closer look of...
Last bit: there's no info on the 2x3 header in the uno documentation. I would copy that over from the avr section. And lastly: It's ok that the jumper wire...
The site used to have instructions on how to use FTDI, but those are gone now. I'd like to see them up again.