Richard Harcourt
Richard Harcourt
@MeteC are you interested in snoCAD-X ? We're looking for help to develop and improve snoCAD-X and make it interoperate with MonkeyCAM, have a look at this and see if...
Enhancement Request - design bottom mould profiles in SnoCAD and exporting into MonkeyCAM to enable cutting of pressing profiles. So when we design a board in snoCAD-X it would be...
Hi team - @RegMeasures @mikemag @NickAlbers , I've had a lot of fun lately with Fusion360 and splines , mainly this started with helping George Gaines @ Chilton Skis with...
I use CAMAX inserts and I'm sure a few others do too. I'll measure up a sample and put the dimensions here. It would be great to have the flange...
Keen to understand how much control is possible over nose and tail planshape. Modern designs rightly or wrongly tend to have more than just curves but instead more sections are...
Create a trench in the core underside before profiling the top side, that follows the top profile of the core, so that you can pour in a sidewall using PU...
Make the cam output full cutout of tip and tail spacer including the 3 straight sides and the shaped end that fits the core, to get the overall core and...
Any thoughts on how we can design press profiles for nose and tail profiles and what's in-between? I use separate nose and tail blocks with a mid section of slight...
Hi @cho45 , this looks very useful and I can see an embedded system in the making with a Raspberri Pi and Arduino or something similar. Whilst not expert with...
hi, I have been wrestling with the package installation on MACOS Ventura 13.2.1 (22D68) and wondered what platform you were using ? Have latest nodejs and python3 installed I get...