Samet Aldas

Hi @Jake-Carter, yes i corfirmed required connections. If camera or dvp connector has damage i can not see signals on GPIO ports JH9&JH8. Am I right ? I will try...

@Jake-Carter Hi again, I tried ImgCapture and i guess i have still same problem.  It is stuck here again. Can i use PCAM ? How can i confirm camera...

@Jake-Carter Do you have any idea ? I guess camera has not get interrupts. How can i hardware reset camera ? Maybe i can applied 3.3V to Vref pins of...

@Jake-Carter Hi again, i contacted with omnivision. I get registers from camera. This problem started when I tried to get data from GPIO ports JH6-9 from evkit. After that i...

 I guess i found the problem. I create a example camera data from fpga and sent to 78002. Then i changed setup of...

@Jake-Carter I sent it. Are you going to close the issue? Maybe I have other questions.

@Jake-Carter Hi again, We figure out something, D0VDD on camera module is 1.8V but on camera.c https://github.com/analogdevicesinc/msdk/blob/187ff74eb762fdda610d856e83775f095b47af96/Libraries/MiscDrivers/Camera/camera.c#L476 GPIO is setting "MXC_GPIO_VSSEL_VDDIOH" so 3.3V. Then we changed this setting to VDDIO...

You are welcome. Should i close the issue ? Maybe I may have other questions later.

@Jake-Carter Hello again Jake :), I want to ask about hsync and vsync. I understand The framework is initialized when vsync is negedge. then I want to write a frame...

I understand. I should send data vsync is positive edge when hsync is high. My first byte is should be here. Am I right? Or after the negative edge of...