Thomas Scheiblauer

icon location Austria

Results 29 comments of Thomas Scheiblauer

Initial layer factor not showing up, if all the other factors are the same.

I also just stumbled over this issue

The "count" value depends on resource attributes that cannot be determined until apply

The same problem manifested itself here today. Yesterday and before it was working fine.

[BUG] SteamVR settings window blank

Same problem here on Gentoo Linux

Reordering of constraints and and elements doesn't work

It's btw. the same with the 220709 LinkDaily release. Reordering parts and items outside an Assembly3 subtree works, though.

Reordering of constraints and and elements doesn't work

The "move item up/down" functionality from the Assembly 3 menu and toolbar works correctly and does what I tried to achieve with reordering. Is this a known problem and the...

Bulging wall above large skin surface - Slicing?

@smartavionics I believe what you are referring to is called "Linear Advance" in Marlin firmware and "Pressure Advance" in Klipper.

Bulging wall above large skin surface - Slicing?

@smartavionics seems to tackle the same issue, though. Linear Advance also modifies the amount of extrusion, depending on printing speed but uses only one parameter, K, which expresses the of...

Bulging wall above large skin surface - Slicing?

@PhilBaz > Ahhh, now Im clear. You think the skin is over extruding at a slow speed leading to increased thickness of the skin, ... But this is exactly what...

implement a generic solution for setting a react key on a component from outside the component.

Another solution for setting the key from outside while keeping the API intact would be binding a dynamic var around the component call. While this would allow for scalar component...

implement a generic solution for setting a react key on a component from outside the component.

I have improved the 'with-key' technique by using a deftype instead of metadata thus allowing to use also scalar values as component state.