sharmstr
sharmstr
Life saver! Thank you!
> @swarfer @sharmstr - (: if you have any comments on it so far (and have some more sample gcode files to throw in the testing pool) > > Basically...
Here's one from Fusion using the Tormach post. I disabled G30 output. [PegBoard-Fusion-Tormach.txt](https://github.com/OpenBuilds/OpenBuilds-CONTROL/files/3575028/PegBoard-Fusion-Tormach.txt)
The parsed info looks good. Ah, ok. During the tool change, will macros be available so I can use a modified G28 for my tool change location instead of having...
How close is this to being released? Not pressuring, but the fusion post will need to be adjusted. Just wondering how much time I have :)
I like it. Can you clarify a few things? 1 - I'm assuming the cutter image will always be the same. If so, I guarantee someone will ask why its...
1 - Oh good luck with that. I can certainly help you with that on the Fusion end. And maybe even the Aspire end (though I only have the desktop...
That should happen in the gcode before the M6. Even your ToolChangeTestPiece doc above raises and stops the spindle before the M6 call. _I've never seen a post that wont...
To be clear, I was talking about my new DROs. Yours do set back to 0.00 when status.comms.connectionStatus equals 0 or 6.
If I change out the g2 with a g3 above, the code works. So seems to only be an issue with G2