shadowano

Node-Red crashes if Elvia returns invalid json

6

This is a serious bug, causing Node-Red to crash everytime the node runs. This is the log from Node-Rd in Home Assistant: > 10 Nov 10:58:16 - [info] Updated flows...

AMs reader fails to connect to MQTT

27

**Describe the bug** When my WIFI/Internet goes down and comes up again minutes later, the AMS reader struggles to recover from the outage. Today, I did nothing to the AMS...

I have webjobs written in .NET Framework 4.7.2 that have lived for years, and have this week upgraded them to use latest Azure.Storage.* nuget packages instead of WindowsAzure.Storage. I have...

Reduction node not turning off the heater causing grid tariff level to break 5 kwh level

10

My complete setup is earlier described on #128 This night from 04-05 I went from an average of the 3 highest days at 4,7 kwh to 5,2 kwh. I identified...

Reset action turns on device outside of schedule

5

Hi, I have seen a couple of times now that the reset and reduction actions run outside of schedule. It happened today, where I had to manually turn off the...

I have implemented the [Capacity part of grid tariff](https://powersaver.no/examples/example-grid-tariff-capacity-part.html) without using Tibber. You can see my setup on issue #128. I provide the nodes that needs Tibber data with data...

Water heater turned off for a complete hour when schedule was on

2

I'm using the following to control my water heater (VVB): Save money using Lowest price and Best Save with schedule merger:  Followed the setup from https://powersaver.no/examples/example-grid-tariff-capacity-part.html#introduction...

Tested with Node-red version 19.0.0?

2

Hi, I'm running Home Assistant and Node-red just released version 19.0.0 which is an big upgrade. I just wanted to know if anyone can confirm that the powersaver nodes works...