Nicolas Baumgardt

Hi George. I recently had problems with newer Arduino Nano V3 bought from aliexpress. They don't work anymore with this firmware (0.6). Did not try with 0.5. However, they work...

You can use the 040 device for the 060 CPU. Works fine in my A4000/060.

Hi - I have currently the same issue using firmware 0.6 on my A1200 with Blizzard 1230 IV, A3000D/16 and A600/ACA620. It does not work with 0.6 but fine with...

> Where exactly is this "echo NOBURST > EnvARC:sana2/plipbox.config " go? The Startup-Sequence, User-Startup or what? It would be nice if there was a little more clarification. This is an...

@10MARC: The Chinese Arduino clones use usually the CH340 USB to Serial chip. The Atmel CPU is the same for the Chinese and original Arduino boards. Therefore you need to...

@10MARC: Yes I also had a bad Chinese Arduino, but most of them work fine. It's a bit strange, that the seller was able to flash the firmware to it...

I guess that [S2_CONFIGINTERFACE is part of a C API](http://wiki.amigaos.net/wiki/SANA-II_Revision_7#S2_CONFIGINTERFACE). MiamiDX and Roadshow do implement it, compare to the [Amiga installation guide here](https://github.com/cnvogelg/plipbox/blob/master/doc/src/amiga.md). Unfortunately I didn't found a possibility to...

Thanks for your answer. In your [intro.md](https://github.com/cnvogelg/plipbox/blob/master/doc/src/intro.md) you write the following: > It has to have the same value as it is used in the plipbox.device driver. The address will...

Thanks for sharing! Works very fine after rebooting the Amiga.

Great, some kind of software reset would be lovely. Many thanks for your efforts!