Regi
Regi
Used my board since Dec 2019. Today after a print the screen just froze. After a power-cycle of the printer the screen is blue-blank.
Tried replacing the skr mini board with my original ender3 board. And it worked just fine, so not a screen or cable issue I guess. Something's up on the skr...
I've tried removing the following lines from bird.js following my intuition and the model seems to do quite well. ` inputs[0] = map(closest.x, this.x, width, 0, 1);` My thinking here...
What has worked for me is adding this in the card configuration: ``` apex_config: yaxis: decimalsInFloat: 3 ```
> > Hi, > > any more Infos would be appreciated: > > Have you tested your camera on a linux pc? Have you read out the camera spezifications there?...
Seems like I just ran into the same issue. Pi4, RPI lite (headless), with SSH. Can't connect (boot up?) after performing hostname change / save.
Right, I see no pi in my router device list. Here's where it stopped:  And afterwards:  Not sure why address is 172... was 192.168... beforehand. So it's not...
hm... I'm connected through cable to my router :/ 
running 1 - network config in ovm-firstaid produces 