rrozema

The same thing happened for me with the MCOHome MH-DT411 Dimmer Switch. I fixed it for this device by setting it's option "12: Reporting interval for dimming level" to 0....

I have looked up the manual for your device, but didn't find a setting like on mine. What you could try however is set option 8 to 0. My guess...

zwave.me has updates available for at least their razberry board. These are available for download from the z-way.me software. I installed the latest firmware into my board and got much...

In Driver.cpp is a method Driver::downloadConfigRevision() that checks for the current node's revision being smaller than or equal to 0 and if found the download of the config file is...

I have described the steps I used to build and debug domoticz together with openzwave from one Visual Studio 2019 solution over at [the domoticz forum](https://www.domoticz.com/forum/viewtopic.php?p=272621#p272621). This should allow you...

The DNS error is because gizmocuz overruled the download location for the openzwave configuration files to point to localhost. He is under the impression that the public location for open...

Come on guys, what's the hold-up here? This is a much requested feature. Plus, current implementation makes for a much cleaner header bar on the energy dashboard and uses the...

> @rrozema Seriously... 7 hours before your comment the change was made.. Not trying to offend anyone here, I do realize and appreciate the HUGE amount of work put into...

I have a use case for adding a limiting sensor as well: In order to further extend my simulations I wish to be able to vary the (dis)charge rate depending...

Another use case could be to simulate 'peak-shaving': lowering the peak use of grid power for the whole-house usage. Under some contracts the energy tariff depends on the peak power...