rrelande

i have also similar signals on CF1 pulse. Most signals will fit into the 50% duty ratio but some spurious signals will not. I assume that the spurious signals not...

I've tried above filrtering solution. it succesfully only considers the pulse width meeting 50% duty ration with 97% exactness. at higher power, 80% of pulses are correct but in lower...

I assume you are referrring to USB pins. They are numbered 1,2,3,4. pins 2 and 3 are the TX/RX, 1and 4 are Vcc and GND depending on the model of...

thanks for this suggestion. in principle it should be supported. There are some highly interesting features available only in ESP32. Despite being claimed as pin-to-pin compatible, there are a few...

bad, bad news regarding the very promising ESP-C3-12F. It is officially discontinued by Ai Thinker. They have a replacement chip which still respect the ESP-12F pins. but it is based...

> The actual measurement was done by measuring the "last" pulse of a measurement period due to instability of the pulse frequency right after setting it. For 222 & 230V...

if you measure 220V or normal power, you don't need the filtering. only if voltage is low (frequency of 2-4Hz), then you will definitely need it. actually fake spurious pulses...

I have the same worrying warning. I have crashes where the debugger points to cronalarms, cannot 100% say it is related but would be good to have a clean compilation...

> Thanks! Which air conditioner model uses this feature? at least Midea air conditioners can switch off the display.

I am having the same issue. my configuration is Arduino esp8266 3.2.0 as i look into the component, it seems to use the LEAmDNS and not the legacy mDNS. reading...