grbl-servo

grbl-servo copied to clipboard

bom dia, eu estou a utilizar o CNC shield para controlar um braço XYZ e queria adicionar um servo para garra do robô. Alguém sabe como e possível fazer?

StraiK3n

Servo motor Arduino

8

Hello every one I am new to Arduino and I am facing the following problem, I have a problem with one of my servo motor (mg996R) it has the following...

SANTILIZER

everytime i try to connect the grbl controller to my pc, there is a problem.This is the code:  When i connect it, there is following message in the...

GulfGulfinson

servo motor move only once

2

It's been more than a month since this problem occurred. But I still haven't found a solution, so I'm asking for help here. I purchased the xy-plotter from the aliexpress...

imfromkr

Configuration on MEGA 2560

4

Hello! I have an arduino Mega 2560, I would like to know the correct pin to control the servo. I am already able to control my machine´s stepper motors for...

earincon198

PWM for servo too weak

1

Hi, Controlling the stepper motors works fine but Im having troubles controlling the servo, so I decided to measure The PWM on D11 and it is too weak. Peak to...

VIKI1992

Hello, I'm trying to make needle cutter with special 0.9i grbl version work when opening grbl controller, however, a 1.1 version appears What could be the cause of this? wr...

Smokie1010

Servo problem

7

Hello I`m havin a problem with the servo I connect the servo corectly (5v gnd and Z+ (D11)) but when i try to use it or when it`s used( M03...

Narcis-Daniel

Drawing 48 Degree Angle

1

Hi I make AxiDraw clone, and using this grbl, everything is fine I am using Grbl Controller 3.6.1, When i draw anything its drawing 48 degrees angel, in inkspace i...

mdaslamknlgit

fix to homing

1

ported these changes to fix homing for corexy: https://github.com/grbl/grbl/pull/818/commits/22d1b2c8d1f15c642d2527807d7e26276489bf1a

CFretter