WirelessPrinting
WirelessPrinting copied to clipboard
probonopd
Print wirelessly from Cura, PrusaSlicer or Slic3r to your 3D printer connected to an ESP8266 or ESP32 module
Hello, in artillery genius it can be connected to the Tx and Rx of the TFT? because I have it connected and it does not print 
When I send a file from the served webpage directly, it uploads correctly and have all the bytes inside (on the SDCard). But when I upload directly from Cura, the...
if i start printing with Cura (4.5) with Octoprint-Cura-Plugin (3.5.12) and Continuous build (bf50a18) the printer stop the print randomly. Im using Wemos d1 mini with SD-Card shield Any Ideas?
I've tried to incorporate an LCD display with u8g2 library, but stumbled upon [bug](https://github.com/esp8266/Arduino/pull/5948) in older versions of esp8266 arduino core. So I tried to update the version but it...
Currently it is cumbersome to update the firmware. It would be nice if one could update from the HTTP interface directly with the firmware being downloaded from a https link...
Printer does not appear in PrusaSlicer. (Tested with **ESP32** on Ender-2) The exact same firmware on ESP8266 __does__ show up in PrusaSlicer. What gives? (Tested with **ESP8266** on RF100) Does...
Remove ElegantOTA because it looks different than thre rest of the UI, adds overhead, and makes the browser require JavaScript. Also, it abuses the update page as advertising space for...
Some printers' boards, such as for instance the Creality Ender 2, don't have RX/TX GPIOs for serial communication, which means this project cannot be used with them. As these are...
The Prusa Mini has a slot for an ESP-01 module. Can we get WirelessPrinting to run on it? The header on the Buddy board:  Connected to the CPU like...