pipes80-collab
pipes80-collab
I was referring to a context where you have the possibility and the support ... sorry if I didn't specify it
> > I was referring to a context where you have the possibility and the support ... sorry if I didn't specify it > > You can use whatever voltage...
better to connect for each potentiometer its 3.3 volts and gnd? or make a bridge and use only 3.3 volts and gnd?
I am modifying the Logitech G29 pedal board to connect it to usb and with the new potentiometers I have problems, connected by soldering because they have the connection oin...
I wanted to say to have the connection holes of the potentiometers wider than the original ones
the 5 volts connection was to try to understand the difference between the 5 volts and the 3.3 volts. I have not connected through 5 volts but through 3.3 volts...
the problem is in reading the axis data created by the potentiometer, so adc, sometimes I can calibrate and slide the axis bar normally while sometimes it remains stationary, so...
> > Ho dei problemi, collegati tramite saldatura perché hanno la connessione oin più grande degli originali. > > Cos'è un "oin"? Cosa intendi per valori bloccati? Se esegui il...
> I 5V passano attraverso il potenziometro e entrano nell'ingresso ST32 (pin ADC, che non tollerano i 5V). > > Se hai problemi intermittenti, probabilmente una scheda / ADC fritta...
same problem with new board, connected the pedals I find that by pressing them several times the axis bar freezes and does not move for a few seconds like frizzy