Philip Pitts

It is possible for the value of a built-in component property to change when used before and after a yield statement within a Unity coroutine. For example, take the following:...

## Problem Loading the wrong settings file will cause the GUI to crash. For example, if you load a EMG settings file as a hardware settings file, the GUI will...

Fix Cyton impedance check board configuration

5

The Cyton impedance check configuration appears to be incorrectly disconnecting SRB2 and using Bias instead. This has led to incorrect impedance measurements as shown in https://github.com/OpenBCI/OpenBCI_GUI/issues/1204. This fix results in...

Cyton impedance checks incorrect at low resistances

4

## Problem Several users on the [OpenBCI forum](https://openbci.com/forum/index.php?p=/discussion/3726/electrode-impedance-test-using-the-gui-widget) report incorrect values from the electrode impedance widget for Cyton when using resistors of 500kOhms or less. Using resistors of greater than...

Linear FFT amplitude is incorrect

1

## Problem The linear FFT amplitude is calculated incorrectly in the FFT Plot widget. ## Expected  In the above example, the time series peak to peak value is...

Ganglion v3 firmware not detected on some MacOS versions

4

## Problem The GUI uses the advertised name of the Ganglion Bluetooth device to determine which major version of the firmware is running. In some versions of MacOS, the device...